VIDEO

DESCRIBE

The U-shape mixing vacuum drier is one of the main drying equipments that make various antibiotics, crystal and other granular materials in pharmaceutical and the chemical industries. It is especially applicable to drying strong adhesive material.

Structure and characteristics:
1.U-shape vacuum drier has a jacket to conduct heat. Its slot cover can open automatically and heat at the same time. There is a hollow agitator which can conduct heat inside the vessel, and this agitator rotates clockwise and anticlockwise, then the material inside the vessel will fully accept heated during forced mixing, speeding up the evaporation, and take away the steam through vacuuming to dry.
2.The equipment can be made from SS304, SS316L, Ti, Hastelloy, PTFE lined or other materials, and the jacket and heat insulation are all made from SUS 304 or 316 L stainless steel, both inside and outside walls are all polished, not only easier to clean to meet the sterile requirement of medicine, but also helping the heat conduction, shorten the drying time.
3.The equipment has bigger area for conducting heat. (Compared with the double-cone rotary vacuum dryer, it has over 1/3 more areas for conducting heat, with 70% loading capacity, 50% drying time less). It has high heat conduction coefficient, small covering area, and lots of other advantages.
4.Low operation cost. The secondary cycloidal-pin wheel reducer is applicable for driving. Its power is 4KW, which is 40% lower than that of other driers of different types. Therefore, the driving power is low and the speed ratio is high. The output torque can greatly reduce power consumption.
5.It is suitable for treatment of raw materials of high moisture. Due to forced mixing and heat transfer, it is the most suitable for processing particles and raw materials of high moisture. The block materials at the inlet will not agglutinate after finishing drying.